12/6/2023 0 Comments Surfshark manual wireguard![]() Using public key:+c523x0yWWG3Xy/h84 AfrO0LDUpfLXoedXmj7QB06Ts= WireGuard keys "/wg/wg.json" already exist The process only took 32 seconds and the noticeable lag (as always) was on: It was an obvious improvement from running this on OpenWrt 19.07.10 ![]() Using the Tut's and Peer Swap and playing around I finally did a call for the script. Kind of topical, but I moved into the new OpenWrt 22.03.0-rc5. Update: Remove the Stubby DNS packages and my speed is nominal. Thank you for the continued support and to all newcomers, dont be shy to ask. following the script commands was easyĬreated a wg0 interface using the script commands in the threadĬonfigured firewall using the scripts in the threadĪfter all this was done, i headed back into openwrt gui interface and could see that wg0 interface said missing protocols.Ī quick restart on the router did the trick and im running stable wireguard surfshark vpn since. Run the scripts as previously stated in the thread and you have all the configs with the info needed.Ĭrontab configuration to automate regeneration of keys. )ĭownloaded and installed win SCP and ssh into root directory of router.ĭownloaded sswg script and extracted to its own folder.Ĭreated directory /wg in root and added the sswg.json and sswg.sh into directory (copied from the sswg script directory )Įdit sswg.json and enter your personal surfsharf credentials and save. all the relevant software installed ( jq, curl, wireguard-app, ntpdate etc. How i did it personally, your mileage may vary.Īfter login. To all newbies ill post my 2 cents as to how the thing works. I have the openwrt surfshark up connected via wireguard using yazdan and sswg script. Hey guys, thank you all and a big shout out to for the continued support. 17:11:03.165115: Trying again to stop zombie tunnel 17:10:21.627157: Trying again to stop zombie tunnel 17:01:37.582344: Trying again to stop zombie tunnel 16:00:41.575181: Trying again to stop zombie tunnel ![]() 14:47:19.413694: Trying again to stop zombie tunnel And to that point OpenVPN to Surfshark worked where Wireguard did not for this period of time below. With the Wireguard App on PC, I can assign the Surfshark DNS servers exactly as assinged from say the Surfshark OpenVPN. By Friday morning it was back to normal without me changing anything.Ĥ unique peers were all not handshaking over the course hours. Log shows, and results were no connection out. However!! Thursday was a bad day for the WireGuard Client app on my pc. I have a valid Surfshark account, my firewall is good, my DNS is good, my device is supported, my Wireguard install on said device is unchanged since. You leave so much to be assumed however, I will offer this. Ubus call system board uci export dhcp uci export network uci export firewall If you feel compelled to investigate, the first question from Paul is just as important as the configurations you can provide by ssh command executed and copied into preformatted text. I copied the configuration into my gl-inet wireguard client to test and it isn't getting online at all
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |